All wicks should be coated in wax before they are used. We offer pre-waxed candle wicks here for customers who prefer the convenience, but we also offer raw candle wick here for customers who enjoy priming their own wicks. Raw wick is unwaxed cotton wick. It is supplied in string-like format and is wound onto a cardboard bobbin. A step-by-step guide to priming your own wicks can be found below:
- Cut the required length of wick off the cardboard spool which it is supplied on.
- Dip the wick into the melted wax and keep the wick in the melted wax until you see air bubbles rise to the surface. This generally takes a few seconds.
- When this happens, it means that the wick has absorbed a sufficient amount of wax and the wick can now be removed from the wax.
- Run your fingers along the wick to remove any extra air bubbles and then lay flat on a hard surface.
- Once this has dried, we recommend repeating this procedure twice, but please note when doing the 2nd and 3rd layer you only need to dip the wick straight in and out. If you leave this in the wax, it will re melt the first layer off the wick.
- Once you have primed the wick, use a pair of pliers to secure a wick sustainer. Sustainers can be purchased from our wick tabs and pins page here.
- Your candle wick is now ready for use!
Comments